Vigo VG6041CHCL6474 Guide d'installation

Naviguer en ligne ou télécharger Guide d'installation pour Non Vigo VG6041CHCL6474. Vigo VG6041CHCL6474 Installation Guide Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 17
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
This Installation Guide uses the following symbols to indicate important information.
Always observe the instructions indicated by these symbols.
VIGO INDUSTRIES INSTALLATION GUIDE FOR
SHOWER ENCLOSURE (MODEL VG06041)
Instructions that, if ignored, could result in death or serious personal injury caused by
incorrect handling or installation of the product. These instructions must be observed for
safe installation.
Maintenance and other important non-personal injury and non-material damage instructions
or statements that should be observed.
It is highly advised to dry fit the unit prior to any installation.
IMPORTANT
SAFETY PRECAUTIONS!
WARNING!
The instructions for the following unit is based off of the Vigo brand shower base. The
instructions can not be provided for any other installation other than that of the Vigo brand.
The warranty will be voided if the following was not performed properly.
CAUTION!
1
Vue de la page 0
1 2 3 4 5 6 ... 16 17

Résumé du contenu

Page 1

This Installation Guide uses the following symbols to indicate important information.Always observe the instructions indicated by these symbols.VIGO I

Page 2

5413This end mustlook inside theshower135G. APPLYING THE SILICONE1. Apply clear silicone caulking along the wall and floor of the shower enclosure

Page 3

MODEL VG0604111

Page 4

IMPORTANT!- WAIT 24 HOURS BEFORE USING SHOWER- DO NOT ALLOW WATER TO DIRECTLY HIT DOOR SEAL STRIPS.CLEANING INSTRUCTIONS FOR THE SHOWER CABIN AND

Page 5

IMPORTANTROLLER ADJUSTMENTS TO ACCOMMODATE OUT OF SQUARE OPENINGS1. Loosen the hex screw to allow for movement. Then place the allen key in the small

Page 6

The small hexhole on on theroller will befacing up on thisroller.MODEL VG06041ROLLER (3)WALLWALLSTRAIGHT WALLSROLLER "A"SMALL HEX HOLEDIRECT

Page 7

MODEL VG06041WALL OUT OFPLUMBWALLTOP ANGLED WALLABTILTS IN AT TOP(EXAGGERATEDFOR PURPOSEOF DEPICTION)FIG. 3The small hexhole on on theroller will befa

Page 8

MODEL VG0604116BOTTOM ANGLED WALLROLLER "A"SMALL HEX HOLEDIRECTIONROLLER "B"SMALL HEX HOLEDIRECTIONWALL DIRECTIONBOTTOM ANGLEDFIG.

Page 9

SHOWER ENCLOSURE LIMITED LIFETIME WARRANTYEFFECTIVE JANUARY 1, 2010

Page 10 - MODEL VG06041

Packing List1. Wall mount bracket (2pc)2. Fixed panel holders (2pc)3. Rollers (4pc)4. Fixed panel (1pc)5. Door (1pc)6. Handle assembly (1pc)7.

Page 11

1. WALL MOUNTBRACKET ASSEMBLY2. FIXED PANEL HOLDER4. FIXED PANEL6. HANDLE ASSEMBLY7. FIXED PANEL BOTTOMCLIP8. DOOR BOTTOMGUIDE9. DOOR THRESHOLD11. STR

Page 12

LEFT INSTALLATIONRIGHT INSTALLATIONDOORDOORDOORFIXED PANELFIG. 1A (GLASS CONFIGURATION DIAGRAM)DOORFIXED PANELMODEL VG06041WARNINGWE STRONGLY RECOMMEN

Page 13

IMPORTANT Verify that the overall size of the shower door opening is appropriate for the shower enclosure. Due to individual site variations, exact

Page 14

FIG.344VIEW FROM TOPOUTSIDE OF THE SHOWEROUTSIDE OF THE SHOWER2 21110FIG. 410111212VIEW FROM TOPINSIDE OF THE SHOWEROUTSIDE OF THE SHOWER4127881474&qu

Page 15

PLATEPLATEHEXSCREWBRACKETBODY151817167188C. INSTALLING THE DOOR1. Remove the rollers (#3) from the box, note that these are fully installed. Caref

Page 16

58954IMPORTANTIN CASE THE THRESHOLD IS CUT TOO SHORT, USE THE THRESHOLD EXTENSION CLIP(#14) TO EXTEND THE THRESHOLD ACCORDINGLY.D. INSTALLING THE

Page 17

788965E. INSTALLING THE HANDLE1. Unscrew the handle holders from the handle assembly (#6).2. Place the handle to the position on the door. Place pl

Commentaires sur ces manuels

Pas de commentaire